10 foot trex boards11/30/2023 ![]() I installed the decking with the aid of a small framing square with a 1/4 in. ![]() I chose to use square slotted deck screws, specifically designed for composite decking and in the same reddish color as the decking itself. Although a hidden fastener system was offered, it was expensive and labor intensive, given that there were no side grooves to install the fasteners into this early product. end posts and post caps all in Trex material. lengths of material to cut into balusters, and 4x4 in. I also purchased railings, additional 2x2 in. I chose the reddish colored Madeira, which was a part of the Trex Accents line, in 20 foot lengths. This first generation Trex, referred to as Trex Origins, measured approximately 1 inch thick, did not have side grooves for a hidden fastener system, and came with a light simulated wood grain finish on one side. ![]() In preparation for the top decking, I subsequently replaced the porch joists with 2x8 fir boards spaced 12 inches apart, even though the company recommended a 16 inch span, to minimize the flex that naturally occurred with Trex lumber. With really nothing else available as a comparison, I chose to use Trex, a deck board made from recycled plastic and wood composites. Here's my product review of Trex decking. This was 1999 and a brand new product was just making its way into the decking and railing industry. While owning a nearly one hundred year old home on the harsh Oregon coast, the time finally came to replace the rotted covered front porch deck and stairs. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |